Quality control for advanced IG production, annual calibration not required!
For more than 10 years the ISO-GAS-Control, has been used around the world for quality control of IG units. Like all HELANTEC units, it uses their proven thermal conductivity analysis technology. HELANTEC developed this sensor system specifically for the insulated glass industry with extensive signal processing and data evaluation. Only this combination enables use of this measuring technology as a test method. The ISO-GAS-Control is highly accurate, extremely robust and works for years with virtually no maintenance. It measures all standard gases and gas mixtures. Gas concentrations are shown directly on the display. A rechargeable battery can be integrated as an option, which enables the devices to also be used directly on construction sites.
HELANTEC Sensor System
HELANTEC developed its sensor system based on thermal conductivity specially for the insulated glass industry, including extensive signal processing and data evaluation. The analyser can be used universally for all standard gases and gas mixtures. Yearly factory calibration is not necessary! Helantec analyzers work with virtually no wear. Gas analyzer will be shipped complete with accessories – ready for analyzing. A sample is injected with a gas syringe. Only minimal gas quantities are required and you can check the function of the gas analyser yourself at any time. This possibility is particularly important as today measurement results must be quickly and easily verifiable.
The HELANTEC ISO-GAS-Control provides:
- Reliable concentration measurements
- Usable for all standard gases and mixtures
- Suitable for multi-coated IG units, triple-glazed units and all spacer materials
- Easy calibration and plausibility check—no supplier annul calibration needed
- Non-destructive measurement methods
- Long service life usually more than 10 years
ISO-GAS-Control Specifications
- Measures gas concentration inside insulating glass
- Suitable for all gases and mixtures
- Measuring method thermal conductivity – reference measurement
- Technology microprocessor controlled
- Measuring range 0 – 100 % gas concentration
- Display of measured value 0 – 100 % gas concentration
- Warm up time 1 hour
- Accuracy better than 0.6% abs. after 1 hour warm up time and calibration
- Stability is better than 2.0% abs. per week
- Calibration 1 point calibration – semi-automatic via calibration mode
- Calibration frequency daily recommended / by the user
- Calibration duration approx. 1-2 minutes
- End point references with 100% filling gas: eight kinds of gas or gas mixtures can be stored
- Simple check of plausibility regarding measured values is possible according ISO 9000 ff
- LCD display – alphanumerical (ASCII)
- Status display not available
- Sampling system via syringe and septa with 50 ml required, non-destructive
- Built-in interchangeable filters
- Power supply 110 – 230 V / 50 – 60 Hz
- Dimension 275 x 320 x 180 mm
- Weight approximately 11 pounds
Gas analyzer is shipped complete with accessories and ready for analyzing.